Thanks for continuing to engage with me- I really appreciate the help, i presume that the terms I will list are all software programs and actions that can be performed within the software
pulse streams of desired width and inter
pulse delay.
A trigger from an A/D value or a pin state...
Yes I could solder, and could source a vector board, and i am more than willing to purchase whatever components and software is required and to spend the time necessary to construct the solution
Thank you, I really appreciate your help, I have something that is tripping out a seperat, critical piece of equipment in a business every day and it is having a financial effect so i really need to find this solution to just make it switch off/on while it is isolated from the rest of the system
I think i can work out the logic circuits ok, but i am an electrician rather than an electronics engineer so I dont even know where to start in terms of sourcing the right software/interface which would allow me to take electrical signals and process them via logic then output back again as...
I think
Hmmm this looks like it can solve my problem perfectly, thank you.
There is a lot of terms in that article which re unfamiliar to me- so here goes I down another series if rabbit holes on a Saturday night !
The problem with those is making the second contactor latch on when the 240v signal appears, but then also remaining on for 5 seconds when the 240v signal disappears
Hi, im hoping someone can help- I wish to design what I thought would be a simple circuit but it turns out it isnt so easy
I wish to control 2 contactors- say C1 and C2. C1 is a NO and its default state will be that its coul is energised. C2 is a NC and its default state will be for the coil...