Recent content by endoramax

  1. E

    Ball Magazine Stop Correctly

    Thank you for your help. I think that hall effect sensor would be great for me.
  2. E

    Ball Magazine Stop Correctly

    Hi Everyone, We are working on making a tennis ball launcher (DIY). We have already designed ball magazine like circle plate with 5 or 6 holes and plate is rotating and one hole match to other hole ball goes through to motors tunnel and launch it. I attached an image of our desing. I would...
  3. E

    DC Motor Driver Problem

    Yes, you are right. I tested the fuse that it is working. Thank you
  4. E

    DC Motor Driver Problem

    Hi I am not sure the board has a voltage regulator vice versa. I supplied 24V but this time I supplied 27.4V (with lipo) for a short time. Could it be affected? Thank you
  5. E

    DC Motor Driver Problem

    I am using this DC Motor as below, https://tr.aliexpress.com/item/32302871282.html?spm=a2g0s.8937460.0.0.26562e0edPFljw (24V 7000 Rpm) While my testing I couldn't observe any having stall situation. I had measured 4 Ampere with a high load.
  6. E

    DC Motor Driver Problem

    Yes it is so cheap and I replaced them with a new one but I want to know why driver stoppped immediately. For example, problem is related to high power consumption (ampere) I need to change some components also I need to decrease the friction level so on.
  7. E

    DC Motor Driver Problem

    Yes, you are right it has a fuse on board. I checked it it works.
  8. E

    DC Motor Driver Problem

    Hi Everyone, I am using this DC motor driver for my tennis ball launcher. When I was testing the machine on the outside one dc motor stopped after a while. I checked two motors that they worked as well. I tested the DC motor driver then I realized that there are no voltages in output. Also, I...
See more
Top