Hello,
I’ve tried connecting the sensor to my DVM but get no change in reading, on the mV scale there is a 0.1mV reading but I think that’s just noise. I get a bigger reading if I move the test leads. Nothing on the V (ac or dc), or when set to Ohms
There are no markings on the sensor.
Maybe an...
Hello,
Many apologies for the length of time in replying but now Christmas is behind us I will hopefully have more time.
Thanks for the replies but before I start desoldering components could someone tell me how to measure or check the motor spindle sensor is working correctly. Please see...
Hello 73’s de Edd,
Many thanks for your reply.
I believe the Hegner saw was built in 1994, as the serial no. is: 65377/94.
Regards,
Paul
Hello Bluejets,
Hegner via the UK agent have got back to me today with this message:
I forwarded your picture over to Hegner and they have confirmed the...
Hello Bluejets and thank you for your reply,
My scroll saw is:
Hegner Multicut 2S Serial No: 65377/94.
I’ll check with Hegner to see if I have the correct motor.
Thanks,
Paul
Hello,
I’ve been given a Hegner scroll saw, which runs but when I turn the speed controller there is no change in speed.
I‘m not very experienced at fault finding at component level and this why I’m asking for your help.
The saw is powered by 230V AC and I’m little apprehensive fault finding...