Search results
-
Wireless lightbulb from Tesla coil
My coil will light a t8 flourecent at 4ft- Bradley
- Post #7
- Forum: LEDs and Optoelectronics
-
High Voltage
A brightness control line? for adjusting wave forms?- Bradley
- Post #9
- Forum: General Electronics Discussion
-
High Voltage
Turns out each output needs its own enable signal with the input signals, I've gotten a reading from 1 HV output but have yet to find my 2 fly-back enable pins, I'm assuming that each HV output needs to be enabled separately from each other. Gonna keep trying :) so well see what happens! Thank...- Bradley
- Post #8
- Forum: General Electronics Discussion
-
High Voltage
The only filter cap I could find is a 35v cap in the top picture on the bottom left of the board, I've ran my voltage to the pins that run to the cap but I get nothing, the scanner worked when it was brutaly gutted lol the board says DC 5v and DC 24v. I'm starting at DC 9v trying to avoid frying...- Bradley
- Post #5
- Forum: General Electronics Discussion
-
High Voltage
Thank you :) I know its the 14 pin terminal, but unsure as to which wires i need to run my DC 24V. Right above the DC 5V its also label DC 24V, put its not specific as as to where these are located on the connector. I've followed some of the circuit and found the ground terminal and a terminal...- Bradley
- Post #3
- Forum: General Electronics Discussion
-
High Voltage
I have a circuit i pulled from a scanner which contains 4 high voltage output pins. 2 of these pins are actually from 2 small flyback HV drivers. DC-600v 10uA DC-1700v 20uA DC-2250v 15uA--Flyback DC-200v 5uA--Flyback I cant seem to determine which pins are my input pins on the circuit... :- Bradley
- Thread
- Replies: 8
- Forum: General Electronics Discussion