750W DC Motor Speed Controler 0-100% with Schematic and PCB Layout

[Youkito1991]

Introduction

----------------

Hi Friends,

I am a newcomer. I try to make 750w DC 24V DC motor speed control. At my project i use TL494 ( ka7500) for control the motor, the current increase by 3 mosfet IRF75n75 ( IFR3205) you can use the biger mosfet for get big power. At this video i show you how to i make it. I don't have the big motor so i use 288W 24V 775 motor for test. You can see the result on my video. The circuit run very well. The total cost of the project is around $10 - $15.


Step 1 Hardware Requirement


You can see all of my project but i will show again

Step 2 Make the PCB​

You can make the PCB use iron method. I have post the Shematic and PCB file. Please download bellow. Or you can order PCB online like me, i order PCB online from JLCPCB.COM. Their price is very low only 2$/10PCB with high quality. I order PCB from their lot of time. You can try. Look the PCB i had order, what do you think about that ?

Step 3 Make the PCB​

The Schematic and layout file. you can download PDF file below and make it at home by yourself.

Step 3 Finsh and Get Big Motor Controler​

I am a newcomer and this is the fist time i post on this forums. If i have any mistake please comment below i will try to fix in the next project. I want to share you all of thing i know. If you have any question for my project, please comment below i will help you.

You can find more project about electrical on my youtube channel: https://www.youtube.com/c/LongTechnical

Thank you very much



View attachment 750W_DC_Motor_Controller_TOP PCB.pdf

View attachment 750W_DC_Motor_Controller_SCH.pdf

View attachment 750W_DC_Motor_Controller_PCB.pdf

 

[davidjackson]

Circuitmaker included one of the most friendly spice simulators, and I still find it more useful and easier to configure and use than the simulation packages in the high end "professional" packages.

Good luck, there are lot of packages at various price points to choose from. 

 

[repairman2be]

Hi Youkito1991,

Nice work!. Thank you for sharing your design and make the PCB available for anyone who wish to use it.

Your description is nice and also the support of pictures is very useful.

Regards, William

 

[Siju]

In a 100A circuit what changes I need to make?

 

[sam.moshiri]

This is a nice circuit also (built with PCB)

 

[Emdad emu]

Sir, Please tell me what is the value of Capacitor (C4) 
?

 



 

 

[Whizard]

Sir, Please tell me what is the value of Capacitor (C4)
?




 



 

It is 100uF electrolytic capacitor with 16V maximum voltage rating. (100uF, 16V)

 

[Prem Chintala]

Hi sir, is this motor can run at same speed when it is loaded. and also could u please explain the how you choose the resistor and capacitor values.

thank you.