cynicmonster
- Nov 10, 2005
- 43
- Joined
- Nov 10, 2005
- Messages
- 43
Hi All.
Well. I have been given a full-blown copier for repair, but I am looking for somewhere to start.
I have the above copier with projector and light pen. The issue is that when it was moved, the fuse oil was spilt.
It seems that only one board has been affected, and from advice, if it is washed and dried properly it MIGHT work. The fuse on the board is intact, but I understand that fuse oil is highly conductive. Is this detrimental to any chips on the board?
When I fire up the unit, I receive an error message "E0000 Turn off power and restart".
Does anyone have an idea where I could find the schem's for this?? Any guidance would be appreciated.
Well. I have been given a full-blown copier for repair, but I am looking for somewhere to start.
I have the above copier with projector and light pen. The issue is that when it was moved, the fuse oil was spilt.
It seems that only one board has been affected, and from advice, if it is washed and dried properly it MIGHT work. The fuse on the board is intact, but I understand that fuse oil is highly conductive. Is this detrimental to any chips on the board?
When I fire up the unit, I receive an error message "E0000 Turn off power and restart".
Does anyone have an idea where I could find the schem's for this?? Any guidance would be appreciated.
