DIY - ARDUINO BASED CAR PARKING ASSISTANT

[Ashish Adhikari]

So this is how I have installed the unit in my garage.

As I walk close to the sensor the light changes from green to yellow to red and ultimately the buzzer goes on when I am too close to the sensor. In my case I have installed the buzzer next to the Arduino however I will recommend you to install the buzzer along with the LEDs. If you want you can also flash the red LED when the buzzer goes on.

So now, my partner can park the car easily without making any assumptions. Doesn't matter how many times she fail her driving test she is not going to break my wall (even when she is drunk). Not that I am asking her to drive when she is drunk (just kidding).

Thanks again for watching this video! I hope it helps you. If you want to support me, you can subscribe to my channel and watch my other videos. Thanks, ca again in my next video.

 

[admin2]

Thanks for sharing this project. I just edited it a bit, so code would look better.

 

[davidjackson]

https://diyfactory007.blogspot.in/

Check out the blog. Briefly explained

 

[Ashish Adhikari]

Impressive. It is not easy to charge the 150ah battery with solar panel directly. For proper charging using solar panel you just need to use a solar charge controller. You must also place the batteries in parallel connection for fast charge. Using solar charge controller avoid reverse current flow from Battery to a solar panel and unharmed pannels from burning. For proper charging your solar panel must create power more than 150w 150w is the threshold point for your charging. More the power added ……charging rate improve.

 

[Poll Zink]

[SIZE=10pt]There are quite a lot of car rental services in my city, but all the cars that I can rent are quite simple. There are no interesting cars.[/SIZE]

 

[David Richard]

There are many car rental services in my city, but all the cars I can rent are easy. No interesting cars.

 

[bidrohini1]

I really like this circuit. Such a small and compact PCB.