Electronic starter kit

[Robert R Perea]

I ordered an Electronic kit, and it comes with components, LED`s, wires ext....,but it also comes with a power supply with connectors a DC-in connector, USB, but no instructions on how to use it. I don`t know what the input voltage should be, Can anyone help?

 

[poor mystic]

Hi
I suggest you post a set of pictures, especially showing the power supply. Please make sure that all the numbers on the power supply are visible in the photos. A few photos of all the other stuff would be good, too.

 

[BobK]

Post a link to the kit.

Bob

 

[kellys_eye]

Sounds like the kit is to be used with a USB-sourced supply i.e. 5V. If the USB lead has a power plug on the end of it and there is a corresponding socket that plugs into a prototype board then this is the most likely answer.

 

[Robert R Perea]

Hi
I suggest you post a set of pictures, especially showing the power supply. Please make sure that all the numbers on the power supply are visible in the photos. A few photos of all the other stuff would be good, too.

 

[Robert R Perea]

Hi
I suggest you post a set of pictures, especially showing the power supply. Please make sure that all the numbers on the power supply are visible in the photos. A few photos of all the other stuff would be good, too.

 

[darren adcock]

Hi Robert. This should help. http://wiki.sunfounder.cc/index.php?title=How_to_use_YwRobot_Power_Supply_Properly

 

[Robert R Perea]

Hi Robert. This should help. http://wiki.sunfounder.cc/index.php?title=How_to_use_YwRobot_Power_Supply_Properly

Thank you so much for your help.