Hi all
I am learning some schematic capture and layout with Eagle PCB.
I eanted to ask whst is generally good PCB design practice. Is it some of the following:
1. Segregate Analogue and Digital circuitry
2. Decoupling caps on all ICs
3. 4 layer stack up woukd be signal gnd power signal
4. Have a layer as dedicated ground
5. Keep digital signal tracks small
6. Adequate filtering and esd protection at inputs to PCB i.e. where USB will be taken in and out
Is there anything else that should be considered especially for EMC/RFI
Thanks in advance
I am learning some schematic capture and layout with Eagle PCB.
I eanted to ask whst is generally good PCB design practice. Is it some of the following:
1. Segregate Analogue and Digital circuitry
2. Decoupling caps on all ICs
3. 4 layer stack up woukd be signal gnd power signal
4. Have a layer as dedicated ground
5. Keep digital signal tracks small
6. Adequate filtering and esd protection at inputs to PCB i.e. where USB will be taken in and out
Is there anything else that should be considered especially for EMC/RFI
Thanks in advance
