Help on wiring up 8 wire stepper motor

[fedrer]

I have just completed all the Ardunio electronic and I cannot make my stepper motor drive. All 3 LED's come on and 2 change colour but as soon as I plug in the stepper either the leds go out or the power supply trips . When I put a multi meter accross the outputs I get about 10v over a and b and the same over c and d.

I am guessing that I have wired up the stepper motor incorrectly unless anyone else has any other ideas. It is the motor from bits from bytes.

I have wired together blue and red/white and made blue/white A and red B

Then wired together black/white and green then made green/white C and black D.


Thanks



_____________________

Life Insurance Quotes
resume writer