Hi, I want somewhere to buy a set of two gears at a 3:1 ratio i.e. 60:20 teeth with a centre hole of 15mm, any ideas?
- Thread starter Maglatron
- Start date
so I found this site but struggling with it with pressure angle,, diametrical pitch and module, for the gears to mesh, any help please guys!?! thanks in advance!
www.mcmaster.com
McMaster-Carr
McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
Last edited:
Hello,
Did you do the calculations?
Engineering toolbox has a page:
Bertus
Did you do the calculations?
Engineering toolbox has a page:
Bertus
Thanks Mr Bertus the gears will be made of carbon steel so I think that the power will be handled fine! just need to work out how to buy gears with matching pressure angle, diametrical pitch and module, for the gears to mesh!
Last edited:
