Phaser 6100 fuser cold

[James Sweet]

I picked up a Xerox Phaser 6100 which starts the warmup cycle and then fails
with a fuser low temp error. I've only done a quick check so far and
verified that the fuser is stone cold. Before I tear into it, does anyone
know if there's a common problem with these? I'm thinking so far either
fuser lamp or a triac on the control board but if I'm barking up the wrong
tree let me know.

 

[James Sweet]

I picked up a Xerox Phaser 6100 which starts the warmup cycle and then
fails with a fuser low temp error. I've only done a quick check so far and
verified that the fuser is stone cold. Before I tear into it, does anyone
know if there's a common problem with these? I'm thinking so far either
fuser lamp or a triac on the control board but if I'm barking up the wrong
tree let me know.

Well this was easy enough, there's a klixon type thermostat in series with
the fuser lamps which is open circuit, the trick now is to track down a
replacement. PW-2N 6075 150E.