R
ronvais
- Jan 1, 1970
- 0
hey,
i want to make a small project and communicate with my circuit through usb
the project should check some sensors and move stepper motors by the program rules.
i got this week my programmer for the controller and went over the datasheet of the controller i got, it doesn't seem hard to get the usb port to listen or write
but the problem comes from the other side: i searched google all last night but i didnt found how to program using .net or mathlab and write and read from the usb port.
can any one refer me to information on programming to usb port??? :-\
i want to make a small project and communicate with my circuit through usb
the project should check some sensors and move stepper motors by the program rules.
i got this week my programmer for the controller and went over the datasheet of the controller i got, it doesn't seem hard to get the usb port to listen or write
but the problem comes from the other side: i searched google all last night but i didnt found how to program using .net or mathlab and write and read from the usb port.
can any one refer me to information on programming to usb port??? :-\
