Latest activity
-
Ttom1970 replied to the thread Amplifier biased too hot?.BTW some people are suggesting that it is ok to leave a trim pot in the RX position rather than have it as a temporary component. Is...
-
Ttom1970 replied to the thread Amplifier biased too hot?.Thanks so much for the very thorough reply. I followed the procedure and it is pretty much sorted. Just need to tune one side a little...
-
THave had a look at the supplied schematic. To adjust the output idle current, use the following procedure. Referring to the amplifier...
-
Dcan´t find a 6KV 28 uF electrolytic cap(perhaps a toothed hen will be easier),but I have several NOS oil filled of similar value...
-
Have had a look at the supplied schematic. To adjust the output idle current, use the following procedure. Referring to the amplifier... -
WHONOES replied to the thread Amplifier biased too hot?.Have had a look at the supplied schematic. To adjust the output idle current, use the following procedure. Referring to the amplifier... -
-
-
-
Fursday Funny
-
davenn replied to the thread Comedy Thread.
-
-
THi everyone, Been a while since I last posted. Hope you are all well. I've just repaired a NAD 3130 stereo amplifier which had a blown...
-
Ppoormystic replied to the thread Book Reviews.Just my general bookshelf but... For general use I like to keep a hard copy of CRC Handbook of Chemistry and Physics. (Wistful...
-
Jjonas123 reacted to Krishna Sankhyan's post in the thread Which MCU do you prefer — ESP32 / STM32 / RP2040 / Arduino? with
Like.
ESP32 for most projects (WiFi + Bluetooth), STM32 for performance, RP2040 for flexibility, Arduino for beginners 👍 -
Ddanadak replied to the thread Tantalum capacitors Vs. Aluminium capacitors for synchronous switching converter input pin..Take a look at this : https://chatgpt.com/s/t_6a01bb7d9fe48191871243f94d92fe56...
