Latest activity
-
MHello, This is my first time posting here 🙂 I joined the forum to ask a question about ECU repair. My Bosch MP5.2 ECU is defective...
-
Martaine2005 replied to the thread Cat door sensor jammed by steel (metal) enforced wall.The electronics are in the front, not the tunnel section you put foil over. Also, adding foil is doing the same thing as the metal... -
GGrahamHarrison posted the thread Anyone identify this connector? in Datasheets, Manuals and Component Identification.Hi All - I wonder if anyone can identify this connector. It is a 51-way SM display ribbon connector on the main board of a Panasonic...
-
-
VVictorZhang_PCB replied to the thread Which MCU do you prefer — ESP32 / STM32 / RP2040 / Arduino?.I agree with your point of view, especially since ESP32 and STM32 have obvious differences in their intended use.
-
VVictorZhang_PCB reacted to rachna062's post in the thread Which MCU do you prefer — ESP32 / STM32 / RP2040 / Arduino? with
Like.
I don’t think there’s a single “best” MCU — it really depends on what stage you’re at and what you’re building. For basic projects or... -
Minder replied to the thread Ignition coil....There is also the later version, used at present on modern auto's, the primary is isolated from the secondary, know as waste spark versions. -
crutschow replied to the thread Ignition coil....Doubt that you get more than a few hundred volts at 60Hz, which likely is not enough to go through the hair to skin of most animals... -
SSandWiz replied to the thread Cat door sensor jammed by steel (metal) enforced wall.I guess it s protection. Probably an insurance issue. But the whole idea was to try and find out if it could be done without replacing...
-
Externet replied to the thread Ignition coil....Thanks. Editing: Yes, at 60Hz. Will it jump 60Hz sparks a reasonable gap not being pulsed DC ? Would it be useable as to electrify... -
crutschow replied to the thread Cat door sensor jammed by steel (metal) enforced wall.So what about adding wood trim to replace the removed metal? What is the purpose of the metal wall?
-
SSandWiz replied to the thread Cat door sensor jammed by steel (metal) enforced wall.Not really...there is only a few cm that the front covers up
-
crutschow replied to the thread Cat door sensor jammed by steel (metal) enforced wall.Could you trim the metal away from around the opening?
-
SSandWiz replied to the thread Cat door sensor jammed by steel (metal) enforced wall.The metal is on the entire front of the wall, and looks the same and has same thickness as the inner wall shown on the first photo...
-
crutschow replied to the thread Cat door sensor jammed by steel (metal) enforced wall.The metal wall apparently acts as a shield that prevents the ready from functioning. Where is the metal in relation to the mounting...
-
crutschow replied to the thread Ignition coil....12Vac would likely saturate the core, causing the primary current to be limited only by the primary resistance. It would increase the...
