Latest activity
-
Jjonas123 replied to the thread Tantalum capacitors Vs. Aluminium capacitors for synchronous switching converter input pin..In my experience, the capacitor's ESR and ripple current rating are usually more important than whether it's tantalum or aluminum. As...
-
SSpiderMan replied to the thread Fixing Bosch Dishwasher that can't turn on.Is your display powered? Any error codes?? If display completely dead, first thing to check for on main power PCB is for cold solder...
-
Ddoc.cotton replied to the thread Looking for a starting point for Micro-controllers....I am older than dirt sooooo. Start with 1 Arduino uno and the Arduino free user interface. Just know that the Arduino is 5 volts on the...
-
If you have seen the locking bar in place, you will have a good idea of its construction. Fabricating a locking bar from scratch is an... -
Before soldering, You can try this hack. Insert the Cable: Carefully slide the ribbon cable into the FPC connector. Shim the Cable: Cut...
-
shim and hot glue or kapton tape is the way to go. -
narkeleptk replied to the thread Anyone identify this connector?.shim and hot glue or kapton tape is the way to go. -
Before soldering, You can try this hack. Insert the Cable: Carefully slide the ribbon cable into the FPC connector. Shim the Cable: Cut...
-
Mmechanic_ replied to the thread ECU repair.Thanks man.
-
MIt probably should be around 200 to 300 mA with RUN applied. Seeing only a few milliamps supports my original post that it is not waking...
-
narkeleptk replied to the thread ECU repair.It probably should be around 200 to 300 mA with RUN applied. Seeing only a few milliamps supports my original post that it is not waking...
-
Mmechanic_ replied to the thread ECU repair.Hello Bertus. Already checked. Its not short ciruited. Thank you for reply. :)))
-
Mmechanic_ replied to the thread ECU repair.I have identified the 12V supply and grounds. I also found the K-line. The ECU has constant 12V, ignition 12V, and three ground pins. I...
-
Mmechanic_ replied to the thread ECU repair.I don't have an ESR tester, but I'll try to buy one in the near future. I checked all the capacitors using a multimeter in capacitance...
