Latest activity
-
-
Ddanadak replied to the thread Is AI making any impact on embedded software development?.I am using it for IOT work. I am not using their tools yet, just write a simple doc with expectations and design goals, and then proceed...
-
Luke11 replied to the thread Have you encountered space-constraint issues in your latest wearable device projects?.Thanks for your suggestions. Applying these into our subsequent projects will take some time. -
Luke11 reacted to Jason Hogan's post in the thread Have you encountered space-constraint issues in your latest wearable device projects? with
Like.
Nice choice with the ST25R3916B for the charger/poller side — it's an absolute tank when it comes to active power output and dynamic... -
Jason Hogan replied to the thread Have you encountered space-constraint issues in your latest wearable device projects?.Nice choice with the ST25R3916B for the charger/poller side — it's an absolute tank when it comes to active power output and dynamic... -
-
davenn replied to the thread Comedy Thread. -
-
Luke11 replied to the thread Have you encountered space-constraint issues in your latest wearable device projects?.Yes, we are using the ST25R3916B for our NFC‑WLC charging dock. Currently we are looking for a small‑form‑factor NFC IC to build a demo...
-
Luke11 reacted to Jason Hogan's post in the thread Have you encountered space-constraint issues in your latest wearable device projects? with Like.
Here is a constructive, embedded-hardware perspective to post in reply to Luke11: Spot on about the pogo-pin corrosion issue, Luke...
-
Ddanadak replied to the thread Discomfort Alert.For small number I/O Molex might be a good choice. But we do not know enough about bandwidth of communication I/O and sensor interface...
-
Rrainyliveshere replied to the thread Discomfort Alert.Not really for the number of I/O pins. I was considering it for modular connections. The sensor could remain on a separate board. The...
-
The threshold value could be simple use of A/D to measure a pot of some kind, a simple knob based setting control. Why edge connector...
-
Ddanadak replied to the thread Discomfort Alert.The threshold value could be simple use of A/D to measure a pot of some kind, a simple knob based setting control. Why edge connector...
-
-
RHello. In 2019, I made this circuit using Seedstudio’s Grove-GSR sensor. I named it ‘Discomfort Alert’. This circuit measured the output...
-
-
Jason Hogan replied to the thread Have you encountered space-constraint issues in your latest wearable device projects?.Here is a constructive, embedded-hardware perspective to post in reply to Luke11: Spot on about the pogo-pin corrosion issue, Luke...
