Latest activity
-
Rrainyliveshere replied to the thread Ceiling fan wall switch vs remote.Back-feeding the receiver's blue output is unsafe. Connection A looks like the receiver's light output. It is designed to supply the...
-
Delta Prime reacted to crutschow's post in the thread Two audio outputs into one 8 ohm speaker with
Like.
Just make sure the two transceiver speaker grounds have no significant potential between them when both are on. The resistor isolation... -
Delta Prime reacted to Martaine2005's post in the thread Burned traces repair help needed with Like.
You can use bare wire. The traces and connections are not insulated. Be mindful of bending the wire where the original track was...
-
TI would like to be able to control the lights with both the remote and the existing wall switch. I believe that I can achieve this by...
-
crutschow replied to the thread Two audio outputs into one 8 ohm speaker.Just make sure the two transceiver speaker grounds have no significant potential between them when both are on. The resistor isolation... -
Ff15radar posted the thread Sony SLV-R1000 — plays a few seconds, tears to B&W, then aborts (pinch roller confirmed glazed, looking for OEM/compatible source + second opinion) in Troubleshooting and Repair.Hi all — working through a Sony SLV-R1000 (S-VHS deck w/ built-in TBC) that's got a specific, repeatable fault. Posting here after some...
-
-
JJerry In Maine replied to the thread Two audio outputs into one 8 ohm speaker.S meter on both. also, each is often receiving on different bands and operating in different modes.
-
crutschow replied to the thread Two audio outputs into one 8 ohm speaker.So how will you now which is generating the sound when both are on? Is there a visual indication?
-
JJerry In Maine replied to the thread Two audio outputs into one 8 ohm speaker.I'd like to monitor both at the same time. Repairs on these transceivers is expensive even w/o shipping to the shop, so I'm really...
-
crutschow replied to the thread Two audio outputs into one 8 ohm speaker.Does either of the tranceivers have an output indicating that they are on? If so, you might be able to use that to operate a relay that...
-
AHello, Here is a page with all kinds of engineering calculators: https://www.engineeringtoolbox.com/ Unfortunately it contains a lot of...
-
JJerry In Maine replied to the thread Two audio outputs into one 8 ohm speaker.I realize I could use two speakers. The speaker I want to use is in a Icom accessory cabinet that matchws the tranceiver,
-
Externet replied to the thread Two audio outputs into one 8 ohm speaker.Complications, complications... Choose your preferred size... Or superglue a couple of your choice, visible or wrapped/behind... -
-
Martaine2005 replied to the thread How Do You Confirm a Suspected Short on a PCB?.I would briefly check the voltage regulators, diodes, capacitors and output transistors for a short. Then I would remove the suspect... -
5013 - Component identification Please accept my apologies for submitting the wrong component datasheet earlier. I understand that...
