Construction went well with very few re soldered points (put a couple of things in the wrong way round, but hey I'm learning).
When I went to do the testing and adjustment it says that I should be reading 5v between TP GND and pin 8 of IC1 but I only get a reading of 2.5v.
Can anyone tell me why this might be and what the consequences of this might be.
It DOES transmitt (I am currently transmitting on 88.9) but I loose the signal after approx 8M from the antenna. Is this related to my drop it voltage measured against what it should be?
Should I trim my antenna to a specific length?
Any comments or suggestions would be much appreciated.