Hollytech Posted February 10, 2010 Report Share Posted February 10, 2010 Hello all,I need to find somebody to built our specific little supply board to manage the battery pack for water cooling pump embedded in our mobile enclosure tower PC, using when we traveling/working mission in hot area africa.I can give all details if somebody there is able to design and built this board for us.Thank you in advance for your help.Holl Quote Link to comment Share on other sites More sharing options...
Alex Tsekenis Posted February 10, 2010 Report Share Posted February 10, 2010 Hello, could you provide some further information on what exactly you want to do? Quote Link to comment Share on other sites More sharing options...
Hollytech Posted February 10, 2010 Author Report Share Posted February 10, 2010 Hello AlexCould you give your mail in PM? by the way i will transmit you the draft draw of general structure i need for this PCB.i Will join you several informations technical pdf of battery pack etc..you need if you can built this board.RegardsHoll Quote Link to comment Share on other sites More sharing options...
Alex Tsekenis Posted February 10, 2010 Report Share Posted February 10, 2010 Hello again.Please understand my reluctance to give out my email address like this.If possible, share what you are trying to do with the community.You don't need to include any confidential details if any. In your first post you say "manage the battery pack for water cooling pump" which is not very clear. For example, do you want to develop a battery charger, a discharge cut-off circuit, a battery monitor...what is it more or less? Maybe your problem has a very straightforward solution. Quote Link to comment Share on other sites More sharing options...
Hollytech Posted February 10, 2010 Author Report Share Posted February 10, 2010 Ok i understand ;) this is below link of my draft draw of my requirements:http://www.zimagez.com/zimage/emb-draft-v12.php Quote Link to comment Share on other sites More sharing options...
Alex Tsekenis Posted February 10, 2010 Report Share Posted February 10, 2010 I see. It happens that I am working on something similar but more complex (diagram attached) at the moment.It will be very hard to fit all the functions in the rectangle on such a small PCB but it is marginally possible given the low power that the circuit must handle.I would like to help you but I am up to my neck at the moment so I can't take on the whole project on my own. I might be able to squeeze some of the subcircuits in my schedule though or provide guidance on the development, something that you can do on this community board too.Hope this is of some help.Visio-POD_SPS_Gen.2_Block_Diagram_Rev3.pdf Quote Link to comment Share on other sites More sharing options...
Hollytech Posted February 10, 2010 Author Report Share Posted February 10, 2010 Yes sure your diagram is quiet more complex ;)I give CreditCard size if possible, if too complex or too expensive I can change the size of PCB: 150x50x10.Also, the function interface usb monitoring is not critical.I hope i find somebody can do this. Quote Link to comment Share on other sites More sharing options...
Hollytech Posted February 13, 2010 Author Report Share Posted February 13, 2010 Up:Somebody here can built this PCB? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.