How to control the HV converter with analog voltage signal

[Dykan]

The HV converter require 24V power supply and some analog voltage signals. I connect two 0~10V voltage signals to the pin of HV converter, 10HVA24-N1. However what I get from the output of HVA is 0V. Is there any thing wrong with my wiring?

 

[Bluejets]

Where did you connect 24v supply..???

 

[Harald Kapp]

Obviously 8-9. The vertical line from pin 8 to + is hard to see (aliasing).

 

[Harald Kapp]

Pin 1 at + 10 V?
The table states "TTL High". TTL is max. 5 V.

 

[Bluejets]

Obviously 8-9.

yes, I ammended my answer afterwards but for some reason ( gremlins) it didn't go through.

 

[Harald Kapp]

Improved image:

 

[Dykan]

Where did you connect 24v supply..???

Pin 1 at + 10 V?
The table states "TTL High". TTL is max. 5 V.

24V is the power supply of HV converter.
Don't worry, the enable pin of HV converter can afford 10V.