D
danadak
- Joined
- Last seen
- Messages
- 1,100
- Reaction score
- 403
Latest activity Postings About
-
-
Ddanadak replied to the thread I need a datasheet.Try here : https://www.ariat-tech.com/parts/ARC760-B?utm_source=chatgpt.com
-
Ddanadak replied to the thread What to study for a semiconductor testing course admission test?.Always take the test, you gain if you fail, you get to see what the focus is.
-
Ddanadak replied to the thread What to study for a semiconductor testing course admission test?.I was fortunate to start my career as a production engineer then went on to testing, writing and debugging code on several different...
-
Ddanadak replied to the thread Suggest device for logging AC current?.From ChatGPT, even some DIY approaches :
-
Ddanadak replied to the thread How Do You Confirm a Suspected Short on a PCB?.Also use a low ohm tester that can help with locality on a board. https://www.elektormagazine.com/news/circuit-a-diy-pcb-short-finder...
-
Ddanadak replied to the thread What to study for a semiconductor testing course admission test?.Not sure if this will help but take a look : https://chatgpt.com/s/t_6a9dc6a75f748191bca1dce2b898798c...
-
Ddanadak replied to the thread Recommended ways to program Uno board.If you have to drive power in the 0-10V area consider using monolithic OpAmps ...
-
Ddanadak replied to the thread Recommended ways to program Uno board.Using a PWM as DAC : https://www.nxp.com/docs/en/application-note/AN14520.pdf https://www.ti.com/lit/an/sloa030a/sloa030a.pdf Page...
-
Ddanadak replied to the thread Help with Mura meter 80M Wiring.You can see where possibly red wire to middle jack. You could try this out and try a 1.5 V battery measurement to see if it makes...
-
-
Ddanadak replied to the thread Help with Mura meter 80M Wiring.What is the model # of the meter ?
-
Ddanadak replied to the thread Recommended ways to program Uno board.The uno board cant generate 0-10V for starters. You would need to amp up a pwm or DAC output for that purpose. Its 6 channels limited to...
-
Ddanadak replied to the thread Is AI making any impact on embedded software development?.I am using it for IOT work. I am not using their tools yet, just write a simple doc with expectations and design goals, and then proceed...
-
Ddanadak replied to the thread Discomfort Alert.For small number I/O Molex might be a good choice. But we do not know enough about bandwidth of communication I/O and sensor interface...
-
Ddanadak replied to the thread Discomfort Alert.The threshold value could be simple use of A/D to measure a pot of some kind, a simple knob based setting control. Why edge connector...
-
-
Ddanadak replied to the thread Burned traces repair help needed.This manual might help...
-
-
Loading…
-
Loading…
