Electric1
- Joined
- Last seen
- Messages
- 50
- Reaction score
- 2
Latest activity Postings About
-
-
Electric1 replied to the thread Open Collector Wired OR logic.Below are the configurations i have for the controller GPIO output level -> Low / High
-
-
Electric1 replied to the thread Open Collector Wired OR logic.Sorry in the table i mentioned wrongly as transistor, i meant was the microcontroller 1 and microcontroller 2 ports. So, in case the...
-
-
I always come across the term open collector is used for Wired OR logic, i tried creating a circuit to understand better Is the above...
-
-
No Rl does not have to be 0 to force Q2 to rob Ibase of Q1. It just has to be a value that hits the Ilmax you calculated. If it did go...
-
I am trying to solve the above circuit two parameters to be found out are The maximum current is IL(max) = 0.7V / 1 Ohm = 0.7A. My...
-
-
Electric1 reacted to crutschow's post in the thread Buck converter calculation does not match with LTspice results with
Like.
What errors? File below: -
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.I was probing at different place sorry my mistake
-
-
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.Can you please share me the .asc file? i still get errors.
-
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.It is asking to operate the switches at 180Degrees out of phase. Yes i updated with S24 diode, but i still face the same problem.
-
-
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.Sorry i was not clear i have updated with nodes, the plots are switch outputs which i expect to be On/Off PWM signals.
-
-
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.Thank you all for the support, i have to perform the analysis on the interleaved buck converter, did not start new thread, it is pretty...
-
-
Electric1 reacted to Alec_t's post in the thread Buck converter calculation does not match with LTspice results with Like.
If a sim is running extremely slowly and taking forever, it can be because any default circuit components in it are ideal ones, e.g. an...
-
Electric1 reacted to bertus's post in the thread Buck converter calculation does not match with LTspice results with Like.
Hello, The 1N914 and 1N4148 are small signal diodes. Better try a ultra fast diode like the UF4007 or an other high current fast diode...
-
Electric1 reacted to Alec_t's post in the thread Buck converter calculation does not match with LTspice results with Like.
The crystal ball is cloudy this morning. Without seeing Fig 6-3a we can't tell if your LTspice circuit is correct.
-
Electric1 reacted to Harald Kapp's post in the thread Buck converter calculation does not match with LTspice results with Like.
Using a component in (LT)SPICE requires the definition of the component's parameters. The generic "D" model is practically useless for...
-
-
Loading…
-
Loading…
