Martaine2005's latest activity
-
5013 - Component identification Please accept my apologies for submitting the wrong component datasheet earlier. I understand that... -
Martaine2005 replied to the thread 5013 - Component identification.Erm, :)
-
Martaine2005 replied to the thread speed controller.27.145 MHz is channel 4 or YELLOW for RC cars, boats etc. It’s now old technology. But to answer your question, it’s definitely possible...
-
Also try cleaning the little disc that spins the DVD. This sometimes helps to restore grip so the disk does not slip. Use alcohol and a...
-
You can see where possibly red wire to middle jack. You could try this out and try a 1.5 V battery measurement to see if it makes...
-
Martaine2005 reacted to danadak's post in the thread Recommended ways to program Uno board with
Like.
The uno board cant generate 0-10V for starters. You would need to amp up a pwm or DAC output for that purpose. Its 6 channels limited to... -
Martaine2005 replied to the thread Recommended ways to program Uno board.You don’t generate its code, you write it. C or C++. But there are 10s of thousands already written on sites like Arduino or github...
-
Martaine2005 replied to the thread Will an over‑discharged "dead" battery be woken up by NFC wireless charging?.I think the battery chemistry would be damaged if depleted below a certain threshold. Reviving a fully depleted/discharged cell may work...
-
Martaine2005 replied to the thread DVD Optical Pickup Assembly.1. Have you tried cleaning the lens?. 2. It’s a risk that might pay off.
-
Martaine2005 reacted to Delta Prime's post in the thread Is AI making any impact on embedded software development? with Like.
yes :)I know 25.810^2 specific useful examples & the associated platform tools; trained neural networks. by the way, 25.810 squared...
-
-
-
The threshold value could be simple use of A/D to measure a pot of some kind, a simple knob based setting control. Why edge connector...
-
Martaine2005 replied to the thread Burned traces repair help needed.You can use bare wire. The traces and connections are not insulated. Be mindful of bending the wire where the original track was...
-
Martaine2005 replied to the thread Burned traces repair help needed.That depends. If it’s a half hour strip down, half hour repair and half hour reassembly, that’s probably not bad. But for a few jumper...