Recent content by roughshawd

  1. roughshawd

    FY 1005S Signal Generator Problem

    Warned you guys about how smart this AI is... Tell oh great one, I remember a couple things from electronics circa 1977.... "...when things blow up, its usually because a component right next door failed." So you might check those resistors and see if they are up to spec.
  2. roughshawd

    Cap swapping on PC motherboards

    I have never, replaced a capacitor with a different size or rating capacitor. However, I have some that are brand new that I will probably never use, and they are the correct voltage. The new ones are 820uf, the blown ones are 1500 and 1800... bad idea!??? no stop me... oh what should I do...
  3. roughshawd

    KZG 6.3v 820uf cap

    I have an HP pavilion that started throwing a BIOHD-4 Error and I found a Smart Error on the main 320g drive. According to the specs, this system can't format anything over 320g, and I have installed two(2) 500g init. So looking the motherboard over, there were a few bulging caps, so I replaced...
  4. roughshawd

    Cordovox piano G keys dead

    The board was scraped through one of the traces... I did a repair, but I don't know if it will work... to scared to test it... there was a wire to the main process board which was disconnected, I don't know, maybe the repairman did a check for something and didn't find anything, the in trying...
  5. roughshawd

    Wallwart specs

    Assuming my VOM works when it reads over 18vdc on my wall wart... Why does my digital oscilloscope show nothing? 20v 50ms....
  6. roughshawd

    Old turntable old axial electrolytic

    dead thread... actually the thing here is that when you don't want to remove something from the board, you just snip the terminals. That was you won't be wondering if the old component is causing the problems you will soon have if the numbers are wrong. Just saying... should use that...
  7. roughshawd

    KORG iS50 Piano Keyboard: Low Phones/Line Out

    If you keep your voice down, and not listen to loud obnoxious noise all day, your ears wouldn't be so sensitive... maybe its not made to be loud, only headphone volume... that is very common in todays studios.
  8. roughshawd

    What are the 3 wires of a computer fan hooked to?

    A fan is sometimes designed to speed up or slow down based on the cooling needs of the system. That way you don't over cool the CPU creating monitor interference. Usually the third wire is a clock wire that gives RPM. The red being hot, and the black being not, if you put a small power supply...
  9. roughshawd

    What kind of equipment would I need to diagnose an Italian Electric piano?

    I have found some very scary things in this electronic piano. Loose wires, cut board traces, chips that I can't find datasheets for, and oddly enough, most of it worked when I got it! I can't find a manual, but I did find a schematic, and thats all I should need.. right. ok I re-connected all...
  10. roughshawd

    Axial C testing

    It was my understanding..,that a capacitor,when tested with a vom, that it would count up until it reached infinity... Why then does an axial just test like a resistor.. or is that a bad cap?
  11. roughshawd

    Cordovox piano G keys dead

    It's lonely on top...
  12. roughshawd

    Cordovox piano G keys dead

    The power board
  13. roughshawd

    Cordovox piano G keys dead

    Time to get serious..... Under the tone control is my worst failure... The power board.
  14. roughshawd

    Cordovox piano G keys dead

    Voltage across the caps, seems nominal... With resistance tests, no power, I have 3 electrolytic caps which test outside of 200k #27, #37, and #51. The last one, #50 if I include the axial reference.
  15. roughshawd

    Cordovox piano G keys dead

    Power on tests. At the mother board I have +9. , +12v and -21v
Top