Herman the German
- Sep 1, 2006
- 179
- Joined
- Sep 1, 2006
- Messages
- 179
:
I found a strong DC motor which I want to use to drill PCBs. It has a tacho-generator output which I think can be used to automatically control a preset rpm.
On a varying load the motor rpm will decrease or increase. It should also be run on 24V for maxium power to give at least 20.000 rpm.
Does anybody have a circuit ready to achieve control?
Thank You.
HtG
I found a strong DC motor which I want to use to drill PCBs. It has a tacho-generator output which I think can be used to automatically control a preset rpm.On a varying load the motor rpm will decrease or increase. It should also be run on 24V for maxium power to give at least 20.000 rpm.
Does anybody have a circuit ready to achieve control?
Thank You.
HtG
