Electrolux tumble dryer with F19 or F12 error codes.

[zio_mangrovia]

My Whirlpool Electrolux tumble dryer, HSCX 90430, stops with F19 or F12 warning and I cannot to decode this error codes. Can you give me support please?

 

[PETERDECO]

From the manual:

F10 to F24
Failure of a component
Switch off and unplug the dryer
.
Wait for about half an hour
.
Plug in the dryer and start the
programme again
.
If the failure persists, call the
After-Sales Service
.

 

[zio_mangrovia]

I already tried it but nothing! I like to solve problem without technician.

 

[Martaine2005]

Does the dryer stop and never start again?
Or does it always start and then stop with the error?.
Do you hear a low volume beep after it stops?.

Martin

 

[zio_mangrovia]

Does the dryer stop and never start again?
Or does it always start and then stop with the error?.
Do you hear a low volume beep after it stops?.

Martin

Dryer starts and after several minutes stops with code error, F12 or F19.
I cannot listen to beep because dryer is outside and sometimes It stops after 1 hour.

 

[Martaine2005]

My first checks would be for fluff build up on the filter.
I had several that stopped because of a tiny bit of fluff. I left the filter off and they ran fine.
Check that first.

Martin

 

[zio_mangrovia]

My first checks would be for fluff build up on the filter.
Martin

Filter inside door? Or foam filter in bottom side ?

 

[Martaine2005]

Yes, the foam filter.

Martin

 

[zio_mangrovia]

Yes, the foam filter.

Martin

I check foam filter, I disassemblied appliance and I check all wire connections, specially among bpm motor and mcu but nothing.
Tumble dryer doesn't dry very well. Suggestions ?