Hi, I purchased a Joyo pxl Pro switcher second hand and have discovered that the end switch (D) is not functioning. I opened up the unit and removing the switch I can see the board is damaged. I'd be incredibly grateful if anybody can have a look at the images and see if there is any way I might be able to repair 
this. I'm happy to try and wire it directly bipassing the board if that is possible but I can find a schematic and my electronics knowledge is very limited. I can see where most of the circuit goes by looking at the board but it gets difficult around the damaged contacts.
this. I'm happy to try and wire it directly bipassing the board if that is possible but I can find a schematic and my electronics knowledge is very limited. I can see where most of the circuit goes by looking at the board but it gets difficult around the damaged contacts.
