Seeking Advice on PCB Design Issue: Trace Width and Thermal Problems

[Ne Quin]

Seeking Advice on PCB Design Issue: Trace Width and Thermal Problems


Hey everyone, I'm working on a PCB design for a small IoT project, and I've run into some issues that I could use some community input on. I'm relatively new to PCB design, so bear with me if these are rookie mistakes!


The Setup

• Board Specs: 2-layer FR4, 1.6mm thickness, 1 oz copper.
  
• Components: ESP32 module, a few sensors (DHT22, BMP280), and a 3.3V LDO regulator.
  
• Power: 5V input via USB, stepped down to 3.3V for the ESP32 and sensors.
  
• Application: Basic environmental monitoring with data sent over Wi-Fi.
  

The Problem

1. Trace Width Concerns: I'm using 0.3mm (12 mil) traces for most of my signal lines and 0.5mm (20 mil) for power lines. The LDO is supplying about 300mA max to the ESP32 when Wi-Fi is active. I ran some trace width calculations using an online calculator (based on IPC-2221), and it suggested 0.8mm for the power traces at this current. My 0.5mm traces are heating up slightly (warm to the touch). Should I be worried about this? Is 0.8mm overkill for a small board like this?
   
2. Thermal Issues: The LDO regulator (a generic 1117-3.3) is getting pretty hot during operation, especially when the ESP32 is transmitting. I’ve got a small heatsink on it, but I’m wondering if I should switch to a different regulator or add more thermal relief. My PCB layout has the LDO near the edge of the board, but there’s not much copper pour around it for heat dissipation. Any suggestions for improving this?
   
3. Ground Plane: I’ve got a ground pour on the bottom layer, but I’m not sure if I’m utilizing it effectively. There are a few areas where the pour is broken up by signal traces, and I’m worried about ground loops or EMI issues. How critical is it to have a completely unbroken ground plane for a low-frequency IoT board like this?
   

What I’ve Tried

• I double-checked my schematic and layout in KiCad, and everything seems to be connected correctly.
  
• I increased the power trace width to 0.6mm on a second prototype, but I’m still seeing some warmth.
  
• I added some vias to connect the ground pour to the top layer, but I’m not sure if they’re placed optimally.
  

Questions

1. Are my trace widths sufficient, or should I bump them up to the calculated 0.8mm for power lines?
   
2. Any recommendations for a better LDO or ways to manage the heat without redesigning the whole board?
   
3. How do I ensure my ground plane is effective? Should I stitch it with more vias or rearrange my signal traces?
   
4. Any other common pitfalls I should watch out for as a beginner?
   

I’d really appreciate any advice or pointers from folks who’ve tackled similar issues. If it helps, I can share snippets of my KiCad layout or schematic. Thanks in advance!