Latest activity
-
crutschow replied to the thread Buck converter calculation does not match with LTspice results.What errors? File below: -
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.Can you please share me the .asc file? i still get errors.
-
RRaulmarian8 replied to the thread Need help with fixing pc subwoofer+speakers please.i found a x-210 without the remote, the guy before just cut-off all wires from the main unit, do you have a wiring diagram or schematic...
-
I have a bluetooth module HW-770C V3.1{receiver} how can i add a antenna for better receive. -
-
crutschow replied to the thread Buck converter calculation does not match with LTspice results.Yes, but you are misinterpreting the meaning of "180 degrees out of phase", (although I think that's technically a questionable use of...
-
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.It is asking to operate the switches at 180Degrees out of phase. Yes i updated with S24 diode, but i still face the same problem.
-
-
crutschow replied to the thread Buck converter calculation does not match with LTspice results.Your switching signals are not interleaved as the test circuit shows, they are just the same signal with inverted polarity. Why? Also...
-
-
Martaine2005 reacted to bertus's post in the thread The position reading from the driver keeps jumping. with
Like.
Hello, A flexible coupling will always have slack. The ones with those plastic or rubber pieces will have more slack than the ones of... -
Martaine2005 replied to the thread The position reading from the driver keeps jumping..I’m no expert by any stretch of the imagination but I would first try a rigid coupler rather than a flexible one.
-
BBrandi posted the thread The position reading from the driver keeps jumping. in General Electronics Discussion.Good morning. I modified a closed-loop stepper motor myself, adding a 500-line incremental encoder to the tail of a Nema 23 stepper...
-
KKrishna Sankhyan replied to the thread Looking for a remote job opportunity at Electronics Lab.Hey! You might want to share a bit more about your skills (like PCB design, embedded systems, testing, etc.) and experience it’ll help...
-
KKrishna Sankhyan replied to the thread Looking for OFF the shelf HDMI/FPGA MIPI DSI convertor with support.Expect some configuration work, not a simple plug-and-play solution.
-
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.Sorry i was not clear i have updated with nodes, the plots are switch outputs which i expect to be On/Off PWM signals.
-
-
Electric1 replied to the thread Buck converter calculation does not match with LTspice results.Thank you all for the support, i have to perform the analysis on the interleaved buck converter, did not start new thread, it is pretty...
-
-
Electric1 reacted to Alec_t's post in the thread Buck converter calculation does not match with LTspice results with Like.
If a sim is running extremely slowly and taking forever, it can be because any default circuit components in it are ideal ones, e.g. an...
