Latest activity
-
SSoremade replied to the thread issue with homemade DC motor + hall effect sensor.Hi everyone, Thanks again for helping. I tried repositioning the sensor in all the the ways but the one in the video is the one that...
-
Ddanadak replied to the thread Latching relays in a control circuit.A couple of cautions when you are working first time with micro boards. 1) When using a scope make sure ground clip on probe cant...
-
-
Hi, A dog. C -
Your circuit will not work in 99.9 %, unless some intelligent programming is used for the ports (see below: risk of short circuit)...
-
Delta Prime reacted to crutschow's post in the thread Latching relays in a control circuit with
Like.
My question was whether you could wire and solder the parts on a vector board if given the circuit schematic and the parts required? -
I would recomend the Vero strip board, there is a free design/layout pgm VeeCAD.
-
pulse streams of desired width and inter pulse delay. Pulses are outputs to a pin to initiate an action like turn on a fan or light. So...
-
Electric1 replied to the thread Open Collector Wired OR logic.Below are the configurations i have for the controller GPIO output level -> Low / High
-
-
CHi, i have a G scale garden railway with stations & sidings. I want to have come up on a screen when a train enters & leaves an area...
-
Electric1 replied to the thread Open Collector Wired OR logic.Sorry in the table i mentioned wrongly as transistor, i meant was the microcontroller 1 and microcontroller 2 ports. So, in case the...
-
-
DDogBark replied to the thread Latching relays in a control circuit.Thank you, i see an Arduino starter kit on amazon, im going to buy it straight away.
-
Ddanadak replied to the thread Latching relays in a control circuit.pulse streams of desired width and inter pulse delay. Pulses are outputs to a pin to initiate an action like turn on a fan or light. So...
-
-
DDogBark replied to the thread Latching relays in a control circuit.Thank you, I will check it out
-
Minder replied to the thread Latching relays in a control circuit.I would recomend the Vero strip board, there is a free design/layout pgm VeeCAD. -
DDogBark replied to the thread Latching relays in a control circuit.Thanks for continuing to engage with me- I really appreciate the help, i presume that the terms I will list are all software programs...
