Latest activity
-
Delta Prime reacted to Martaine2005's post in the thread Help diagnosing AC Sliding gate controller stops halfway with
Like.
Upon further reading, your units limit switch looks to be similar to this, so the set up would be very similar too. Make sure the... -
Delta Prime reacted to 73's de Edd's post in the thread Help diagnosing Trinitron KV-32FV27 with Like.
Sir Coolsuggies . . . . . Consulting ye olde Sunny Service manual . . . . . on their page # 41. You need to check out the "C " board...
-
davenn reacted to Chryse's post in the thread Indexes for "Everyday Electronics" and "Practical Electronics" magazines with Like.
I have compiled indexes for both "Everyday Electronics" and "Practical Electronics" magazines. The indexes are formatted as MS Exel... -
Chryse replied to the thread Indexes for "Everyday Electronics" and "Practical Electronics" magazines.Danadak I am not planning on doing any more of these indexes. When I started these two I was typing everything in to spreadsheets... -
Ddanadak replied to the thread Indexes for "Everyday Electronics" and "Practical Electronics" magazines.Can you do Electronics World and Radio Electronics and CQ Magazine at https://www.worldradiohistory.com/Home-RAM.htm I started working...
-
Chryse posted the thread Indexes for "Everyday Electronics" and "Practical Electronics" magazines in General Electronics Discussion.I have compiled indexes for both "Everyday Electronics" and "Practical Electronics" magazines. The indexes are formatted as MS Exel...
-
SSoremade replied to the thread issue with homemade DC motor + hall effect sensor.Hi everyone, Thanks again for helping. I tried repositioning the sensor in all the the ways but the one in the video is the one that...
-
Ddanadak replied to the thread Latching relays in a control circuit.A couple of cautions when you are working first time with micro boards. 1) When using a scope make sure ground clip on probe cant...
-
-
Hi, A dog. C
-
Your circuit will not work in 99.9 %, unless some intelligent programming is used for the ports (see below: risk of short circuit)...
-
Delta Prime reacted to crutschow's post in the thread Latching relays in a control circuit with Like.
My question was whether you could wire and solder the parts on a vector board if given the circuit schematic and the parts required?
-
I would recomend the Vero strip board, there is a free design/layout pgm VeeCAD.
-
pulse streams of desired width and inter pulse delay. Pulses are outputs to a pin to initiate an action like turn on a fan or light. So...
-
Electric1 replied to the thread Open Collector Wired OR logic.Below are the configurations i have for the controller GPIO output level -> Low / High
-
-
CHi, i have a G scale garden railway with stations & sidings. I want to have come up on a screen when a train enters & leaves an area...
