Latest activity
-
HHulya posted the thread Handheld Unit Power Supply Voltage Attenuation in General Electronics Discussion.Excuse me, I have a question for you all. The manual pulse generator is more than 20 meters away from the control cabinet. The original...
-
Hi forum friends, It’s not always easy or possible to open site tools (110V) to measure current by opening the circuit and putting the... -
-
MManutr83 reacted to hevans1944's post in the thread Wanted: MOTRONIC DIGITAL DC MOTION CONTROLLER / SOFT STARTER with
Like.
It appears, as we say here in the States, that you are SOL on your quest. I asked Grok 4.5 for help and copied its reply below. I also... -
-
davenn replied to the thread Comedy Thread. -
-
partyanimallighting replied to the thread No output from fog machine PCB.That then points to one of your green diodes being blown in the series line. It's only 3 on the PCB so the blown culprit will be easy to... -
Ccesarg209 replied to the thread No output from fog machine PCB.So if the LED driver IC is blown would it still output the 12 volt voltage? Because I tested the wire for that specific green LED and it...
-
partyanimallighting replied to the thread No output from fog machine PCB.If the green LEDs aren't working it's either 1 blown green LED (most probably) or the LED driver IC on the PCB that drives the bank of...
-
Ccesarg209 replied to the thread No output from fog machine PCB.Yeah I was messing with the fog machine last night , and I figured out the connector of this board. It has 4 letters where it hooks up...
-
-
CCrafts4Me posted the thread fan doesnt specifically say waterproof can I use it anyway? in General Electronics Discussion.hi you have given me advice on my model building regarding the reptile humidifier i have rebuilt it all to be "waterproof" all the...
-
-
partyanimallighting replied to the thread No output from fog machine PCB.No luck. The simplest method would be to meter from one of de-soldered points (left or right side) on the diode plate and look for...
-
partyanimallighting replied to the thread No output from fog machine PCB.Let me see if I have any pictures saved.
-
Ccesarg209 replied to the thread No output from fog machine PCB.Does anyone have a clear picture of how the RGB lights are supposed to be hooked up? mine got desoldered at the PCB board of the RGB's...
-
Ddanadak replied to the thread AI Data Centres.Totally worried about AI but look at what we been doin.....
-
-
Ddanadak replied to the thread AI Data Centres.And then we have the human factor of change for many : https://chatgpt.com/s/t_6a6dca25ccc88191bf4e2e9fa3c370ec
