Jump to content
Electronics-Lab.com Community


  • Posts

  • Joined

  • Last visited


Everything posted by mitchnid

  1. Hello All I’m in school in Electronic and want to use this 30v current/voltage controlled power supply as my final second semester Fabrication project... I etched a board and soldered all the components on. When I power it up I cant get more then about 7.5 v out. Pin 6 off of U1 is fixed at 11.2v, pin 3 on U2 varies from 0 o 11.2v as I vary p1, but pin 6 never gets above about 8 volts... As well LED D12 is always lit no matter where I set P2... Any help would be appreciated... Thanks David
  • Create New...