Jump to content
Electronics-Lab.com Community

arman_linkin

Members
  • Posts

    4
  • Joined

  • Last visited

    Never

arman_linkin's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. i check all of the diodes and transistors and ... but it steel doesnt work
  2. One more thing....I built this project and I tested it with 1A 24V trans(beacause I didnt have 3A Trans)but it doesnt worked correct.LED was always On and the out put voltagewas 0.41 V evev when I turn p1 and p2
  3. beacause of my bad english...Icant understand your answer. i am also an amature in electronic.so please explain it more clear can you draw a diagram (or mybe a shematic) for me (about out put transistors)??????? :-* i cant understand it. and what is the range of each voltmeter????which of them show the current flowing trough the load.and which of them show the amps that was set with p2. note : its not NOT NECESSARY for me to set current at special place.but it IS important for me to show the current flowing trough the load... so help me please with diagram not with written message. :-* I hope you apologize me for my gossips :-[ :'(
  4. (exuse me for my bad english.i am only a learner) hi to all I want to built this power supply.but I have a question : 1.if I use an ammeter for it ...it will show the ampere that the load use or the ampere that was set ? thank a lottttttttttt. Arman
×
  • Create New...