[3V LED Chaser project]

So I just solder a wire from the copper tape to join the curcuit at the nearest place to the negative terminal? & By The Way, when you call for 1M Audio taper (logarithmic) potentiometer, is that the same thing as 1 Meg...etc.?

[3V LED Chaser project]

By the way, I found these--> http://www.allelectronics.com/cgi-bin/category.cgi?category=340500&item=LED-94&type=store Ill probably use them.

[3V LED Chaser project]

Alright, my last two questions. Sorry for all the questions. Im a Newb.
:-[ What exactly is the curcuit's ground? Can you show me an axample of what you're talking about?

[3V LED Chaser project]

Okay, I should be able to find Red/Orange Ultra-Bright 1.8V/2.2V at 20mA on allelectroinics.com or something right? But whats all this about joining the shielding to the circuit? If it's not too much trouble, can you explain why I would have to do this?

[3V LED Chaser project]

So I can use Ultrabright Low voltage LEDs? that would be great because the smaller the cavity the better. I can get copper shielding tape like this to put in the cavity. Do you think it could work under the strings with that? I think ill use the regular chaser project you made before. So can I use the "3V LED Chaser" project and just substitute with ultrabright low voltage LEDs?

[3V LED Chaser project]

Thanks for the advice. Im looking forward to the 6V Ultra-Bright LED Chaser. I figured the LEDs would make some kind of hum. The thing is is this is what us guitarists call a "project guitar". It's all hot-rodded with special pickups and stuff. I have broken pieces of mirror all over it and the only parts that aren't covered are the area under the strings and below the two pickups. So I guess I'll put it on the lower horn. Also, I forgot to ask, I'd like to put a on/off push switch in to turn it on and off. Maybe when you make the new mod circuit, you could tell what kind and where to put that in? Thanks.

[3V LED Chaser project]

Hey everyone. Im 17 and new to electronics and this is going to be my first real project. I play guitar in a band and I want to install this project in my guitar under the strings, and between the pickups for a little added stage wowing. Here is a picture of a guitar similar to the one I want ot put this in.--> As I said I want to put it between the two pickups(2" gap), under the strings. I planned on making a back cavity (for those who don't know what that is, it's this)--> to house the project, and drill holes for the LEDs and pots. Question #1 is, Where can I get all the parts to make this project? #2 Will the project make a hum or buzz in my sound? #3 Any advice? Thanks to any and all responses.