Tinker Unique

A very similiar project is posted as a 3v chasing circuit. Was dropped from 7. to 3v using two batteries / driving 10 LED's. The project I have in mind will be on/in a fibreglas/ casting resin spare tire cover with a dragon "blowing" flame, and will only be lighted when the brake light is on ( 3d brake light ). And could be activated in/for car shows. It will not be 'that bright' but will be seen mostly during night driving. I have a 555 and 1470 IC and use Rasdio Shack LED's in craft projects sometimes with a resistor using 2 AA batteries. I can get 12v LED's for the dragon. I've seen where the IC's can handle the 12v supply OR use a resistor.

Not sure about an indoor atnenna, but have installed several outdoor antenna for UHF / VHF / CB receivers that are simple to elaborate and very capable of "collecting" world wide communications.

Viewed the 10 rotating (chasing) LED's on a CD with 9v. supply. - Nice. Would like the schematic modifications ( if needed ) for a 12v auto supply AND if a couple the LED's listed could be doubled and work the same. >> Lighting a 'dragons breath (flame) to appear as if it was 'active" in a resin spare tire cover to be activated when the stop light comes on.