Jump to content
Electronics-Lab.com Community

Search the Community

Showing results for tags 'isp'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Electronics Forums
    • Projects Q/A
    • Datasheet/Parts requests
    • Electronic Projects Design/Ideas
    • Power Electronics
    • Service Manuals
    • Theory articles
    • Electronics chit chat
    • Microelectronics
    • Electronic Resources
  • Related to Electronics
    • Spice Simulation - PCB design
    • Inventive/New Ideas
    • Mechanical constructions/Hardware
    • Sell/Buy electronics - Job offer/requests
    • Components trade
    • High Voltage Stuff
    • Electronic Gadgets
  • General
    • Announcements
    • Feedback/Comments
    • General
  • Salvage Area

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


Website URL


Yahoo


Skype


Location


Interests

Found 1 result

  1. Hello,everyone These days I met a problem about STM32F103VCT6. After the second edition of the STM32F103VCT6 single-chip microcomputer system I made recently, I found that I could not download by ISP, and the isps did not change the circuit line completely compared with the first version. However, it is ok to use the SW download mode, and the ISP serial port can communicate normally when the program is good. Under the ISP mode, I shook hands with serial assistants send bootloader byte 0 x7f, returned to 0 x7f and 0 x79 two bytes, while the normal board should only receive a byte 0 x79. Why is this 0 x7f, has anyone encountered the same situation, and how to solve. The methods I have tried: 1. Replace single chip microcomputer, max232 and peripheral capacitance, serial port signal driver IC, etc 2. The power circuit has also been changed, and the first plate of power supply has been tried.
×
  • Create New...