Search results

  1. ante1

    Monitor Problem

    Try to measure the Mosfet sitting close to the flyback!
  2. ante1

    Headlight Flasher

    I wouldn
  3. ante1

    Monitor Problem

    Hi Doc, Yeah, hungry for current!  ;D
  4. ante1

    Component symbol... CRT's PCB

    I found this info: "Viewsonic 1769gs-2 monitor FCC gss17005 has no hi-voltage.  Fbt, hot, etc seem ok.  Replaced lm-2931 & 74hc00 on the aux. board.  All ps voltages ok" "If the HV builds and collapses, and everything else is ok, then you may have a shorted transistor on the CRT socket...
  5. ante1

    Monitor Problem

    Hi John, An orange power led often means
  6. ante1

    OVER-/UNDER-VOLTAGE PROTECTION CIRCUIT ANALYSIS

    This is true only under certain load conditions, not without or with light loads!
  7. ante1

    Component symbol... CRT's PCB

    If you tell us the make and model maybe someone got a schematic or a manual for your monitor! Also a picture of the PCB with the remains might help!
  8. ante1

    Newbie needs help with a project

    Hi Jim, I don
  9. ante1

    Please Tell me about OP AMP

    Just browse through some op-amp datasheets and you will get plenty of ideas!
  10. ante1

    0-30 Vdc Stabilized Power Supply

    I know what you mean; I made my first PCB in the early seventies. Keep up the good work! ;D
  11. ante1

    NEED HELP IN A BAD WAY.... LED PROJECT

    You might be able to use the UAA180.
  12. ante1

    Voice playback

    ISD 1416 / 1420 for 16 or 20 seconds and the ISD 2560 / 2590 for 60 or 90 seconds!
  13. ante1

    IC replacment for transistor tester

    Why replace it?  ???
  14. ante1

    0-30 Vdc Stabilized Power Supply

    Well, you are doing a nice and tidy layout the hard way then!  ;D
  15. ante1

    0-30 Vdc Stabilized Power Supply

    Hi subumann, That looks just great! I have to ask; do you plan the layout for the board on paper or do you have some software to do the work? Good work!  ;)
  16. ante1

    Sony Car Stereo CDX-GT460US so sensitive to cell phone that it switch itself off

    There have been cases where Nokia phones have damaged ECU
  17. ante1

    Pump protection circuit

    Hi Steve, Yes, I believe you should use an amplifier and a lower value for the resistor. You might also get away with using a smaller input voltage for the A/D (fewer bits) and still be able to sense the current with enough accuracy.
  18. ante1

    Advice on AC motor speed reduction?

    Hi Guys, From what I have seen; a single phase motor with a starting cap on the side is actually a 3-phase motor able to run on a single phase by means of this cap!? In that case it should be possible to run the motor from a three-phase frequency converter if the cap is removed and the jumpers...
  19. ante1

    Plessey ZN416E AM Receiver

    Wow, I certainly did not expect this for a part not produced for more than a decade!  :o Good job John!
  20. ante1

    Momentary switch

    I wouldn
Top