Search results

Search Forums New Posts
  1. Maglatron

    help with IR2110 chips

    because the magnets are not passing the coins, the coins are attached to the magnets! there will however be eddies in the bolt but that is unavoidable with my setup going to try and get 20volts AC from the weaker coil
  2. Maglatron

    help with IR2110 chips

    Seeing as the voltage doubled when I halved to gap, I'm anxious to see the result after adding in the coins and lowering the distance between the magnets and coils further.
  3. Maglatron

    help with IR2110 chips

    I disagree the penny's will only further the magnetic field I'm attaching the 1p's to the magnets!!
  4. Maglatron

    help with IR2110 chips

    Will try anyway see if it makes a significant change mind the pun I think it will work rather well, we'll see later on if I get a session to work on the machine!
  5. Maglatron

    help with IR2110 chips

    going to lessen the gap even more, with penny's and get the best reading good to know about the true RMS aswell! going to put the 200w resistor 150ohm and take an alternating current reading
  6. Maglatron

    help with IR2110 chips

    there both pretty good! your thoughts? thanks, did you read the bit about the resistor getting very hot?? the second meter says this in the description (Frequency (Hz) 10Hz-1MHz±)
  7. Maglatron

    help with IR2110 chips

    I'm using this one and also have the other too...
  8. Maglatron

    Comedy Thread

    I really wanted to find out the lowest rank in the army, but people kept telling me it was private!
  9. Maglatron

    Comedy Thread

    what do you call a pumpkin divided by it's diameter, pumpkin pi
  10. Maglatron

    Comedy Thread

    the farmer thought he had 97 cows but when he rounded them up he had 100!
  11. Maglatron

    help with IR2110 chips

    anyone? I have the penny's ready to stick now!!
  12. Maglatron

    Comedy Thread

    did you here the one about the broken pencil, nevermind, it's pointless
  13. Maglatron

    help with IR2110 chips

    so then is it a trade off between voltage and inductance
  14. Maglatron

    help with IR2110 chips

    if I dig out the 200watt 15ohm resistor and then use my clamp meter I can also get a current reading I just had a genius ideo too! I'm going to stick 1 pence piece to each magnetto close the gap further
  15. Maglatron

    help with IR2110 chips

    I also have a 20ohm resistor rated 500w
  16. Maglatron

    help with IR2110 chips

    Also when holding the wires onto the meter, I'm getting a little AC tingle which is really promising!
  17. Maglatron

    help with IR2110 chips

    so alor, I have remounted both of the coils colser to the magnets ( used a piece of corragated cardboard as a spacer ) now the new arrangement the coil that has always been better at 650 rpm makes 20.91volts AC and the weaker one 15.72volts AC then I wanted to use the resistor to get that other...
  18. Maglatron

    help with IR2110 chips

    how many? I'll get the coils closer to the magnets also theres a 16mm hex bolt one the end of the 1cm core if that changes anything
  19. Maglatron

    help with IR2110 chips

    is your estimate still 5 coils minimum?
  20. Maglatron

    help with IR2110 chips

    is this meters or cm?
View older results
Top