[Help] PCB Family connector unknown

[jmuelas]

Hello all!

I am inmerse in a personal proyect to replicate a old PCB for my home heater and everything was fine until I tried to find this very connector.







This connector has 2 different pitches:

• - 300 mils between the first and second pin
• - 200 mils for the rest of the pins

I tried to find it in several manufacturers but without any result

Could someone help me?

Thanks and regards!

 

[shrtrnd]

Methinks it may have been a custom-built connector for your device(?)
When I run into a problem like this, I find socket pins that fit the posts, and
connect the wires onto the individual sockets that fit the posts. That way
you can still remove the sockets if needed later. Use heat shrink over the
sockets so that there's no chance of short circuiting the loose individual sockets.
Good luck with whatever you do.