Help with diagnosing problem with pcb from charge controller

[sandtaz]

Any further suggestions for diagnosing my problem. Thanks.

 

[(*steve*)]

I can't think of anything else simple to test.

I don't suppose you still have the manual for this? There may be some clues as to what we can test in there.

 

[sandtaz]

I can't think of anything else simple to test.

I don't suppose you still have the manual for this? There may be some clues as to what we can test in there.

Steve, first thank you for your help. Too bad we did not find a problem. I do have the manual, but it will not be of any help. When it discusses a problem with the controller, it says to contact the company. But remember, they are gone. Perhaps someone else on this forum will read this thread and come up with a suggestion, or suggest someone I could send the board to for help. I did contact one company, but they wanted a minimum of $300 just to take a look. Have a great day. Tom.

 

[(*steve*)]

Yeah, I realise all of that, it's just that there might be some information in the manual which might give me some ideas.

 

[sandtaz]

Yeah, I realise all of that, it's just that there might be some information in the manual which might give me some ideas.

If you want, I could scan and send. I can skip the part on the gen and concentrate on just the controller. Prob less than ten pages. Let me know.

 

[sandtaz]

If you want, I could scan and send. I can skip the part on the gen and concentrate on just the controller. Prob less than ten pages. Let me know.

Here is a link to the manual http://www.windenergy.com/sites/all/files/Whisper 200 Manual 3-CMLT-1033_01 Rev D_FINAL.pdf