Search results

  1. ante1

    vehicle rpm based switch- help

    Hi pilottx, Welcome to our forum, Is this for the NO2 valve? ;D What kind of output do you get from the ECU, pulsetrain or a voltage or something else?
  2. ante1

    URGENT urgent

    Hi Shahriar, Do you think this circuit would drive a speaker or speakers?
  3. ante1

    re-wiring to use batteries???

    Hi John, Yes Staigen is correct! If you rewire it the right way and have a bit of luck here (if nothing got destroyed) it should work fine!
  4. ante1

    Nokia 446 XS 19" Monitor

    Hi, Well it’s an intermittent problem, suddenly the picture gets toned in purple (I can still se the picture clearly and use the device). It comes and goes, sometimes a few days between and sometimes only hours between. It lasts for anything from 10 sec to 20 min and at one time the monitor...
  5. ante1

    Nokia 446 XS 19" Monitor

    Hi Guys, I have some problems with a computer monitor a Nokia 446XS which is the short neck 19” version. I have tried to find a service manual for it but the “XS” version is nowhere to be found it seems! I would be very grateful for any help on this one! Thanks!  :)
  6. ante1

    Need Service Manual for Philips 29GX1896

    Hi sekartut, I hope this will help you! ;) [attachment deleted by admin]
  7. ante1

    hacking a solid state relay

    Hi Daniel, Can you tell us a little bit more about the “cabinet mounted oven with a sailing thermostat” so we know what you are trying to do here. There might be some brilliant ideas out there! ;D
  8. ante1

    220V to 110V

    The maximum power consumption for the unit in watts (W) or (VA) is a good place to start.
  9. ante1

    re-wiring to use batteries???

    Hi John, If you can, post the circuit you have made so we can see what’s wrong! BTW, have you tested this fan controller in its normal environment to make sure it’s OK?
  10. ante1

    Help On Another Transistor Question

    I call it idling!  ;D
  11. ante1

    hacking a solid state relay

    Good hunting on ebay! ;)
  12. ante1

    Car Amp!!!

    You should make the power cables as short as possible and from at least 6 square mm wire.
  13. ante1

    Car Amp!!!

    What size of fuses was included with the amp?
  14. ante1

    220V to 110V

    Hi felto, Well, I can’t be sure about this because 140W and 1mA does not match by far. I need more specific values to be able to say for sure and not mess up things for you!  :-\
  15. ante1

    hacking a solid state relay

    Hi daniel, The circuits are not too hard to build but if you are going to make complete molded blocks with terminals, it’s cheaper and simpler to buy them!
  16. ante1

    0-30 Vdc Stabilized Power Supply

    I think 0 Volts is not the same as 0.0000 Volts, it all depends on how many decimals you like to introduce.  ;D
  17. ante1

    URGENT urgent

    The LM 386 works between the mic and the speaker!
  18. ante1

    DC-DC Converter

    Hi arthurq, Welcome to our forum. The LD1086 is a low drop type linear regulator and you don’t need low drop type here, also you don’t need the heat from linear regulation. I have used the  http://pdfserv.maxim-ic.com/en/ds/MAX724-MAX726.pdf with success in several applications and I think it...
  19. ante1

    7v5

    Yes, I think you will be fine with the BZX55/C7V5.
  20. ante1

    7v5

    What’s the input voltage and what’s the value of the series resistor?
View older results
Top