Search results

Search Forums New Posts
  1. B

    About Radio Transmitters

    Makes one wonder why you would even bother when radios like this are so cheap to buy.($30) http://hobbyking.com.au/hobbyking/store/__9041__Hobby_King_2_4Ghz_6Ch_Tx_Rx_V2_Mode_1_.html
  2. B

    Noob Question About Current From Voltage Regulators

    Careful there...we offer our help from a vast knowledge base and if you choose to use words like "attached circuit" it is meant normally to mean a circuit diagram.
  3. B

    ne555 timer ciruit

    Switch will have to be momentry contact normally open ..... plus above advice...no idea what second part of your circuit is supposed to do. You need to do some reading really. The above site is very good.
  4. B

    Strange problem with transistors flipping current

    I'd be using relays or something like attached.
  5. B

    Noob Question About Current From Voltage Regulators

    Attachment not there.....
  6. B

    Tektronix 465B N/W

    First thing would be to get a manual for the scope. Found one....... 3/4 way down the page on the left it says..... This file is downloadable free of charge ( processing changes to get manual ) Size about 50 meg. I'd be looking for dried out electrolytic capacitors...
  7. B

    ne555 timer ciruit

    As Davenn says, the reset (pin 4) should be held high (connect to positive rail) I see you have 6.8uf capacitor, which, if you still use the 1 meg resistor (cannot see the value you used) will give timing at around 7.5 seconds. What is connected to " puzzle" wiring..?? Also see #6. Can you see...
  8. B

    Adjustable Low Current Power Source. Need schematic.

    Then one needs a solid reference to calibrate the calibrator.
  9. B

    ne555 timer ciruit

    If the output(pin 3) is connected to a transistor base, you will need a resistor in there otherwise it will cook the 555, probably the transistor also. Very difficult to follow your layout...can you not just draw a basic circuit of what you have?
  10. B

    Moving electronic part/switch/relay - does this exist?

    Could try a small resistor tied to a piece of bi-metal ...but again...2 * 4 mm and flat at that :D Resistor buried in a piece of pc board with a bubble of glad-wrap over the top....mm... that's it for meo_O
  11. B

    problem programming pics

    To start with, this is not correct..... for( ; ; ) ...... study this ..... http://www.mikroe.com/download/eng/documents/compilers/mikroc/pro/pic/help/for_statement.htm Then this may also get you going.... https://electrosome.com/led-blinking-pic/ Also here...
  12. B

    Electronics PDF file

    One cannot measure the amount of water in the oceans with a teaspoon, neither can one measure the air in the atmosphere by breathing in and out. Same goes for electronics in a pdf file.(Not possible.)
  13. B

    Moving electronic part/switch/relay - does this exist?

    Dead short IC...?? :) No, nothing I can think at that size.
  14. B

    Amps higher than voltage possible?

    Generated current...fault current can be much more
  15. B

    External power supply for DSLR camera

    Sounds like a job for a car battery ...40Ah..and a good regulator or inverter
  16. B

    Amps higher than voltage possible?

    Believe it. Unless there is some current limiting device or factor. This is the exact reason why those who know tell you not to fool around with mains supply or high capacity battery systems.
  17. B

    Guidance for choosing PLC

    Specs for the first unit (model DAM126) shows "relay output use same ground, that is all the relays have one side of each contact connected to ground. I imagine this is logic level ground, or perhaps 24v dc ground. Specs for the second unit ( model DAM 130) shows "relay outputs seperately...
  18. B

    UV Sterilization Light

    Your 4-8w starter should work fine. Usual range for starters in Aus is 4-20W or 4-80W. The former preferred for the smaller tube and for other applications. With too large a starter, it will never stop flickering. Reason it looks like a neon is because it is very similar .....filled with gas and...
  19. B

    Need advice to buy a generator

    Gensets are not rated in kw but kva as the power factor of the load is unknown.
  20. B

    UV Sterilization Light

    No, didn't get my info off "how stuff works" but rather from the old grey cells where it was put during my apprentiship some 40 years ago. (which is why it may seem a bit different)o_O
Top