Pioneer SX-424 - Speaker Protection Board

[bundyboy]

Hi,

I have Pioneer SX-424, and I want to buy Speaker Protection Board. But I dont know will it work ?

I want to install a speaker protection module in my Pioneer SX-424. The module requires an AC power source between 12V and 24V.

Does the power transformer in the SX-424 have a secondary winding that provides this voltage?

I want to buy this: https://www.aliexpress.com/item/100...|x_object_id:1005009166826153|_p_origin_prod:

Thank you.

 

[crutschow]

What exactly is your concern, that you want to add a speaker protection circuit?

 

[bundyboy]

What exactly is your concern, that you want to add a speaker protection circuit?

when I turn on the receiver, I can hear pop in speakers.
also sometimes when i turn off, also i can hear pop in speakers.
from what i found, Pioneer SX-424 does not have Speaker Protection Board with delay.
so I want to install some kind Protection Board with delay for speakers.
with the aim that when I turn on the receiver, I don't hear a pop, the same when I turn off the receiver.

 

[crutschow]

To see if that circuit could actually eliminate the speaker pop, disconnect the speakers before turning on the amp, and than connect the speakers after the amp has been on for a few seconds.
If there's no pop, then the module you referenced should eliminate the pop.

 

[Martaine2005]

The switch that you bypassed A, B, A+B, did it have any circuitry on it?.

 

[bundyboy]

Hi,

Yes, I can try that.
switch that I bypassed A, B, A+B, I think it does not have any circuitry on it
it looks like this:

also on other forum i found this:

 

[bundyboy]

i bought this: https://s.click.aliexpress.com/e/_ooP9MGt

I hope it works well