Join the Community
Main Menu
M5Stack PaperDIY Is a 4.7-Inch ESP32-S3 E-Paper Development Board
Helix 521-PLC Fanless Edge Controller Runs CODESYS on Intel Core Ultra
Infineon Adds Post-Quantum Security to Quad-Motor Control MCUs
HPMicro HPM5100 MCU Series Brings 480 MHz RISC-V and 16-bit ADCs
Polyimide Tape for PCB Masking: Avoiding Edge Lift and Residue
Prevent Post-Launch Application Failures with Real-World Network Simulation
The Approach to AI Infrastructure Is the Real Bubble
Mastering the Curve: Layout Strategies for FPC Bend Radius and Reliability
Single Pair Ethernet: One Twisted Pair, Full Ethernet Performance
Analog To Digital Conversion - Sampling and Quantization
Positive Feedback in Electronic Circuits
Temperature Sensors
High Current Half Bridge with Over-Current Shutdown
3-Wire Electret Microphone Pre-Amplifier
12W Step Up DC-DC Converter using MAX1771
Sound to Light Color Shield for OLEDUINO v2
An Introduction to RF Theory, Practices, and Components: The Ins and Outs of RF
The Growing Decentralization of Power Grids
Bob @ robertgawron.blogspot.com has posted a Geiger-Muller project that can be used with Arduino or any other microcontroller...
Bob has tipped us with his latest project.
TC-Engineering has documented their efforts to program a Spartan 6 FPGA using a DIY PCB.
Ken Shirriff has done a detailed teardown of the popular 555 timer IC.
Markus has designed a single-sided ESP-12/ ESP-07 breadboard adapter that uses easy to find SMD parts and has on-board voltage...
The project designed around L293D IC.
The Minibot is a small autonomous robot vehicle that uses phototransistor that can detect lightness patterns on the ground to...
The circuit is a simple digital frequency meter that is made of a frequency-to-voltage converter and an analog-to-digital display...
by Denis Meyer @ elektormagazine.com writes about the new Samsung bio-processor: Samsung Electronics Co.
OSHChip is a general purpose processor board based on ARM Cortex-M0 32 bit processor running at 16 MHz.
This unipolar stepper motor driver circuit is used to drive a 12V unipolar stepper motor with a current rating of 1.25A.
Edward Mallon @ edwardmallon.wordpress.com gives us a detailed explanation about cheap RTC modules found on ebay and other places.
