Join the Community
Main Menu
M5Stack PaperDIY Is a 4.7-Inch ESP32-S3 E-Paper Development Board
Helix 521-PLC Fanless Edge Controller Runs CODESYS on Intel Core Ultra
Infineon Adds Post-Quantum Security to Quad-Motor Control MCUs
HPMicro HPM5100 MCU Series Brings 480 MHz RISC-V and 16-bit ADCs
Polyimide Tape for PCB Masking: Avoiding Edge Lift and Residue
Prevent Post-Launch Application Failures with Real-World Network Simulation
The Approach to AI Infrastructure Is the Real Bubble
Mastering the Curve: Layout Strategies for FPC Bend Radius and Reliability
Single Pair Ethernet: One Twisted Pair, Full Ethernet Performance
Analog To Digital Conversion - Sampling and Quantization
Positive Feedback in Electronic Circuits
Temperature Sensors
High Current Half Bridge with Over-Current Shutdown
3-Wire Electret Microphone Pre-Amplifier
12W Step Up DC-DC Converter using MAX1771
Sound to Light Color Shield for OLEDUINO v2
An Introduction to RF Theory, Practices, and Components: The Ins and Outs of RF
The Growing Decentralization of Power Grids
This reference design is a simple VGA signal generation that uses the Freescale’s MC9S08SH16VTJR, which is an 8-bit m...
by Graham Prophet: LT8330 is a current mode, 2 MHz step-up DC/DC converter with an internal 1A, 60V switch.
In this episode Shahriar takes a close look at one of Keysight (Agilent) InfiniMax III active probes.
The LTC®3335 is a high efficiency, low quiescent current (680nA) buck-boost DC/DC converter with an integrated precision coulomb ...
The electronics trend in automotive is continuously rising due to the demand in the market.
In this episode Shahriar and Timo demonstrate the design methodology of an FPGA based 32×32 RGB LED matrix driver.
Atmega8 Development Board provides a very simple and cost effective platform for prototyping solution.
This project illustrates the use of a microcontroller(MCU) to generate different types of sound.
The major component of this circuit is Microchip’s SST89E54RDA-40-C-PIE, which is a pin-for-pin compatible with typical 8051 m...
by Susan Nordyk @ edn.com: The ISL94203 battery-pack monitor IC from Intersil monitors, protects, and cell-balances three- to...
Zak’s Electronics Blog published a new library and breakout board for MCP2221 USB to UART interface IC: This is a library for i...
In this tutorial, you’ll learn how to burn Arduino bootloader on a new ATmega328 using USBasp ISP programmer.
