PI Temperature Control Amplifier for Thermoelectric Cooler (TEC) Driver
https://www.electronics-lab.com/project/pi-temperature-control-amplifier-for-thermoelectric-cooler-tec-driver/
This is a simple Proportional, Integral (PI) temperature control amplifier. A complete thermoelectric cooler (TEC) controller can be created using this PI amplifier and OPA569 Power Op-Amp or other output amplifiers such as DRV591, DRV592 and DRV593. Proportional-integrator compensation is simpler to adjust and often provides an adequate thermal transient response to the TEC driver […]
Unipolar-to-Bipolar Level Translator 0V to 5V Unipolar to ±10V Bipolar Converter
https://www.electronics-lab.com/project/unipolar-to-bipolar-level-translator-0v-to-5v-unipolar-to-%c2%b110v-bipolar-converter/
This design is intended to translate a small unipolar signal to a wide bipolar signal. A common application is to translate a 0 to 5V DAC output to a ±10V bipolar signal. All resistors are 1% but it is advisable to select 0.1% 20 ppm/°C resistors for good gain, offset accuracy, and drift tolerance. A […]
Smart Power Module for 3-Phase Motor – 5A
https://www.electronics-lab.com/project/smart-power-module-for-3-phase-motor-5a/
This is a Smart power module project designed for Small Power AC Motors. The FNB40560 chip is the heart of the project. A compact inverter project is ideal for small power motors such as fans and pumps. H-bridge configuration can also be created for low current high-voltage brushed DC motors. The Inverter project supports loads […]
3-Phase Advance Motion Module – 400VDC – 4A
https://www.electronics-lab.com/project/3-phase-advance-motion-module-400vdc-4a/
This is an advanced Motion module providing a fully featured, high-performance inverter output stage for AC induction, BLDC and PMSM motors such as refrigerators, fans, and pumps. This module is based on NFA50460 chip which integrates the optimized gate drive of the built−in IGBTs (FS4 RC IGBT technology) to minimize EMI and losses, while also […]
Voltage Controlled Amplifier – VCA
https://www.electronics-lab.com/project/voltage-controlled-amplifier-vca/
The project presented here is a Voltage Controlled Amplifier (VCA). A VCA board helps users control the Audio Level from a remote potentiometer. It requires a single-ended audio signal in the input. Gain control voltage can be adjusted through an on-board potentiometer or use an external potentiometer connected to CN4. The project works with a […]
RMS Noise to DC Converter – RMS Noise Measurement
https://www.electronics-lab.com/project/rms-noise-to-dc-converter-rms-noise-measurement/
This mini-module helps users to measure the RMS noise of AC signal. Apply the AC noise signal to the input and the circuit outputs a DC voltage. Signal bandwidth is 1Khz to 100Khz and input sensitivity is 1 μVolt RMS. The LT6203 ultra-low noise, low power op-amp amplifies the low-level signal. Further, this signal is […]
RMS To DC Converter
https://www.electronics-lab.com/project/rms-to-dc-converter/
This is a Precision Micro-power true RMS-to-DC converter built using LTC1966 RMS to DC Converter chip and op-amp LTC1494. The RMS to DC that is Converted by LTC1966 and op-amp is used as a post filter to improve AC Response with Offset and Gain Correction. The circuit converts the AC signal into DC. The project […]
Lamp Flasher with Timer IC and MOSFET for Automotive Applications
https://www.electronics-lab.com/project/lamp-flasher-with-timer-ic-and-mosfet-for-automotive-applications/
This is a mini flasher board that can drive high-power LED or a lamp, mainly designed for automotive applications. The project consists BD9555FVM-C timer chip and MOSFET. The circuit is configured as a flasher, and can also be used as a PWM driver with an adjustable duty cycle and frequency. Capacitors C2, R4, and PR1 […]
One Channel RF Remote Relay Switch
https://www.electronics-lab.com/project/one-channel-rf-remote-relay-switch/
The project described here is one Channel RF remote receiver Relay board. The project is built using LICAL-EDC-DS001 chip from LINX. The board consists of Encoder/Decoder chip, 433Mhz RF Receiver module, 10 x jumpers to set the address, a Relay to drive the output, U2 5V regulator, header connector for data outputs for controlling external […]
High-Voltage (180V) – High-Current (30mA) Operational Amplifier Module
https://www.electronics-lab.com/project/high-voltage-180v-high-current-30ma-operational-amplifier-module/
This project provides a platform to evaluate the OPA462 high-voltage, high-current operational amplifier. Multiple component footprints allow the most common circuit configurations. The board accommodates high-voltage and high-current operational amplifier OPA462 from Texas Instruments. A High-Voltage Noninverting Amplifier, AV = 17 V/V. An example application circuit is given below. The board is capable of operating […]