Dual-Level Float-Cum-Boost Charger with Pre-Charge for 12V – 3 to 6Ah Sealed Lead Acid (SLA) Batteries

---

https://www.electronics-lab.com/project/dual-level-float-cum-boost-charger-with-pre-charge-for-12v-3-to-6ah-sealed-lead-acid-sla-batteries/

This SLA Battery charger project is the right choice if you want to obtain maximum battery service life and capacity, along with acceptable recharge time and economy, constant current, constant voltage, and even charge a deeply discharged battery. The project contains all the necessary circuitry to optimally control the charging of valve-regulated lead-acid batteries. The […]

Low Voltage Lead Acid Battery Disconnect board – Prevents Deep Discharge Of 12V Lead Acid Battery

---

https://www.electronics-lab.com/project/low-voltage-lead-acid-battery-disconnect-board-prevents-deep-discharge-of-12v-lead-acid-battery/

This project helps to optimize the 12V lead-acid (SLA) battery life as it prevents the battery from going into deep discharge. It is very important to disconnect the load before the battery enters into deep discharge as this may destroy or damage the battery cells.  The circuit shown here turns off the load before the […]

6V Lead Acid Battery Charger using BQ24450

---

https://www.electronics-lab.com/project/6v-lead-acid-battery-charger-using-bq24450/

6V Lead acid (SLA) battery charger project is based on BQ24450 IC from Texas instruments. This charger takes all the guesswork out of charging and maintaining your battery, no matter what season it is. Whether you have a Bike, Robot,  RC Car,  Truck, Boat,  RV, Emergency Light, or any other vehicle with a 6v battery, […]