Modules Projects
Carrier Board for Advanced Phase-Shift PWM Controller UCC3895
This is a Phase-Shifted Full-Bridge PWM UCC3895 carrier board that contains all of the features necessary to implement a phase-shifted full-bridge topology power converter.
3 Digit Common Cathode 0.5″ – 7 Segment Display Module (Multiplexed)
This is a 3 Digit 7-segment display project that contains 3 x Common Cathode displays, current limiting resistors or each LED segment, 3 x PNP Transistor on each common cathode for multiplexing etc.
4 Digit Common Cathode 0.5″ – 7 Segment Display Module (Multiplexed)
This 4 Digit 7 segment display project contains 4 x Common Cathode displays, current limiting resistors or each LED segment, 4 x PNP transistors on each common cathode for multiplexing, etc.
2 Digit Common Cathode 0.5″ – 7 Segment Display Module (Multiplexed)
This 2 Digit 7 segment display project contains 2 x Common Cathode displays, current limiting resistors or each LED segment, 2 x PNP Transistor on each common cathode for multiplexing, etc.
4 Tactile Switch Breakout Board
This breadboard-friendly board breaks out all 4 tactile switch signals and includes pullup resistors configured so that the outputs read low or high when configured common VCC or GND.
Optically Isolated Analog Input Module for Arduino
This isolated analog input module is useful for interfacing Analog signals of various types originating from analog sensors and field devices.
USB 10-digit Seven Segment Display Module
This project is about an open-source, USB based, 10 digit seven segment display unit.
LED Based Large Size 7 Segment Display
LED Based Large Size 7 Segment Various Display Schematic & PCB Layout
Proto Board with On Board 10X Box Header Connector
Proto Board with On Board 10X BOX Header Connector for Micro-Controller Development Board
4 Digit 7 Segment 0.5″ Multiplexed Display Module
4 Digit 7-Segment Multiplex Display project will provide 4 digit of multiplexed display for your project.
8 Tactile Switch Board with High & Low Outputs
8 Tactile Switch Input Board is a simple PCB offering an easy connection of a standard 10-pin Box Header connector to 8 small type Tactile Switch with a jumper selectable pull-up/pull-down of resistor network connected in parallel.
8 Led Output Display Module
Schematic Photos